DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
573
Restrictions
Only Administrators can issue this command.
Example
To clear all STP counters on the Switch:
DGS-3000-26TC:admin#debug stp clear counter ports all
Command: debug stp clear counter ports all
Success.
debug stp state 53-6
Description
This command is used to enable or disable the STP debug state.
Format
debug stp state [enable | disable]
Parameters
state - Specify the STP debug state.
enable - Enables the STP debug state.
disable - Disables the STP debug state.
Restrictions
Only Administrators can issue this command.
Example
To configure the STP debug state to enable, and then disable the STP debug state:
DGS-3000-26TC:admin#debug stp state enable
Command: debug stp state enable
Success.
DGS-3000-26TC:admin#debug stp state disable
Command: debug stp state disable
Success.
To Next Page
Loading...
