D-Link DGS-3000 - Config Scheduling

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
686
DGS-3000-26TC:admin#show per_queue bandwidth_control 10
Command: show per_queue bandwidth_control 10
Queue Bandwidth Control Table On Port: 10
Queue Min Rate(Kbit/sec) Max Rate(Kbit/sec)
0 640 No Limit
1 640 No Limit
2 640 No Limit
3 640 No Limit
4 No Limit No Limit
5 No Limit No Limit
6 No Limit No Limit
7 No Limit No Limit
DGS-3000-26TC:admin#
config scheduling 69-5
Description
This command is used to configure the traffic scheduling mechanism for each CoS queue.
Format
config scheduling {ports [<portlist> | all]} <class_id 0-7> [strict | weight <value 1-127>]
Parameters
ports – (Optional) Specify a range of ports to be configured.
<portlist> - Enter the list of port used for this configuration here.
all – Specify all the ports to be configured.
<class_id 0-7> - Enter the 8 hardware priority queues which the config scheduling command will
apply to. The four hardware priority queues are identified by number from 0 to 7 with the 0
queue being the lowest priority.
strict - The queue will operate in strict mode.
weight - Specify the weights for weighted round robin. A value between 0 and n can be specified.
<value 1-127> - Enter the weights for weighted round robin value here. This value must be
between 1 and 127.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the traffic scheduling CoS queue 1 to weight 25 on port 10: