D-Link DGS-3000 - Chapter 29 Energy Efficient Ethernet (EEE) Command List

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
331
Chapter 29 Energy Efficient Ethernet
(EEE) Command List
config eee ports [<portlist> | all] state [enable | disable]
show eee ports {<portlist>}
config eee ports 29-1
Description
This command is used to enable or disable the EEE function on the specified port(s) on the Switch.
NOTE: The two functions, EEE and ERPS, are mutually exclusive.
Format
config eee ports [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter a range of ports to be configured.
all - Specify to configure all ports.
state - Specify the EEE state. The default is disabled.
enable - Enable the EEE function for the specified port(s).
disable - Disable the EEE function for the specified port(s).
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable the EEE state on ports 2-5:
DGS-3000-26TC:admin#config eee ports 2-5 state enable
Command: config eee ports 2-5 state enable
Success.
DGS-3000-26TC:admin#
show eee ports 29-2
Description
This command is used to display the EEE function state on the specified port(s).