D-Link DGS-3000 - Disable Sntp; Config Time

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
827
DGS-3000-26TC:admin#enable sntp
Command: enable sntp
Success.
DGS-3000-26TC:admin#
disable sntp 87-5
Description
This command is used to turn off SNTP support.
Format
disable sntp
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable SNTP:
DGS-3000-26TC:admin#disable sntp
Command: disable sntp
Success.
DGS-3000-26TC:admin#
config time 87-6
Description
This command is used to configure time and date settings of the device.
Format
config time <date ddmthyyyy> <time hh:mm:ss>
Parameters
<date ddmthyyyy> - Enter the system clock date. An example would look like this: '30jun2010'.
<time hh:mm:ss> - Enter the system clock time. An example would look like this: '12:00:00'.