D-Link DGS-3000 - Delete Ipv6 Route; Show Ipv6 Route

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
444
delete ipv6route 41-2
Description
This command is used to delete an IPv6 static route. If the next hop is a global address, it is not
needed to indicate the interface name. If the next hop is a link local address, then the interface
name must be specified.
Format
delete ipv6route [[default | <ipv6networkaddr>] [<ipif_name 12> <ipv6addr> | <ipv6addr>] |
all]
Parameters
default - Specify the default route.
<ipv6networkaddr> - Enter the destination network route.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters
long.
<ipv6addr> - Enter the next hop address for the route.
<ipv6addr> - Enter the next hop address for the route.
all - Specify to delete all created static routes.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
Delete an IPv6 static route:
DGS-3000-26TC:admin#delete ipv6route default System 3FFC::1
Command: delete ipv6route default System 3FFC::1
Success.
DGS-3000-26TC:admin#
show ipv6route 41-3
Description
This command is used to display IPv6 routes.
Format
show ipv6route {[<ipv6networkaddr> | <ipv6addr>]} {static}
Parameters
<ipv6networkaddr> - (Optional) Enter the destination network address of the route to be
displayed.
<ipv6addr> - (Optional) Enter the destination IPv6 address of the route to be displayed. The