DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
110
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To clear the ARP table:
DGS-3000-26TC:admin#clear arptable
Command: clear arptable
Success.
show arpentry 7-6
Description
This command is used to display the ARP table. You can filter the display by IP address, MAC
address, Interface name, or static entries.
Format
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> | static | mac_address <macaddr>}
Parameters
ipif - (Optional) The name of the IP interface the end node or station for which the ARP table
entry was made, resides on.
<ipif_name 12> - Enter the IP interface name here. This value can be up to 12 characters
ipaddress - (Optional) The IP address of the end node or station.
<ipaddr> - Enter the IP address here.
static - (Optional) Displays the static entries in the ARP table.
mac_address - (Optional) Displays the ARP entry by MAC address.
<macaddr> - Enter the MAC address here.
Restrictions
None.
Example
To display the ARP table:
To Next Page
Loading...
