D-Link DGS-3000 - Config Dscp Trust

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
694
DGS-3000-26TC:admin#show 802.1p default_priority 1-10
Command: show 802.1p default_priority 1-10
Port Priority Effective Priority
---- ----------- ------------------
1 5 5
2 5 5
3 5 5
4 5 5
5 5 5
6 5 5
7 5 5
8 5 5
9 5 5
10 5 5
DGS-3000-26TC:admin#
config dscp trust 69-13
Description
This command is used to configure the state of DSCP trust per port. When DSCP is not trusted,
802.1p is trusted.
Format
config dscp trust [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter the list of port used for this configuration.
all - Specify that the command apply to all ports on the Switch.
state - Specify to enable or disable to trust DSCP. By default, DSCP trust is disabled.
enable - Specify to enable the DSCP trust state.
disable - Specify to disable the DSCP trust state.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
Enable DSCP trust on ports 1-8.