D-Link DGS-3000 - Show Vlan

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
28
config port_vlan 3-7
Description
This command is used to set the ingress checking status, the sending and receiving GVRP
information.
Format
config port_vlan [<portlist> | all] {gvrp_state [enable | disable] | ingress_checking [enable |
disable] | acceptable_frame [tagged_only | admit_all] | pvid <vlanid 1-4094>}(1)
Parameters
<portlist> - Enter a range of ports for which you want ingress checking. The port list is specified
by listing the beginning port number on the Switch, separated by a colon. Then highest port
number of the range (also separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash.
all - Specify all ports for ingress checking.
gvrp_state - (Optional) Enables or disables the GVRP for the ports specified in the port list.
enable - Specify that GVRP for the specified ports will be enabled.
disable - Specify that GVRP for the specified ports will be disabled.
ingress_checking - (Optional) Enables or disables ingress checking for the specified portlist.
enable - Specify that ingress checking will be enabled for the specified portlist.
disable - Specify that ingress checking will be disabled for the specified portlist.
acceptable_frame - (Optional) The type of frame will be accepted by the port. There are two
types:
tagged_only - Only tagged packets can be accepted by this port.
admit_all - All packets can be accepted.
pvid - (Optional) Specify the PVID of the ports.
<vlanid 1-4094> - Enter the VLAN ID here. The VLAN ID value must be between 1 and 4094.
Restrictions
Only Administrators and Operators can issue this command.
Example
To sets the ingress checking status, the sending and receiving GVRP information:
DGS-3000-26TC:admin#config port_vlan 1-5 gvrp_state enable ingress_checking
enable acceptable_frame tagged_only pvid 2
Command: config port_vlan 1-5 gvrp_state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Success.
DGS-3000-26TC:admin#
show vlan 3-8
Description
This command is used to display the vlan information including of parameters setting and
operational value.