DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
881
Appendix A
Password Recovery
Procedure
This chapter describes the procedure for resetting passwords on D-Link switches. Authenticating
any user who tries to access networks is necessary and important. The basic authentication
method used to accept qualified users is through a local login, utilizing a Username and Password.
Sometimes, passwords get forgotten or destroyed, so network administrators need to reset these
passwords. This chapter explains how the Password Recovery feature can help network
administrators reach this goal.
The following steps explain how to use the Password Recovery feature on D-Link devices to easily
recover passwords.
Complete these steps to reset the password:
1. For security reasons, the Password Recovery feature requires the user to physically
access the device. Therefore this feature is only applicable when there is a direct
connection to the console port of the device. It is necessary for the user needs to attach a
terminal or PC with terminal emulation to the console port of the Switch.
2. Power on the Switch. After the ‘Starting runtime image’ message, the Switch will allow 2
seconds for the user to press the hotkey [^] (Shift + 6) to enter the “Password Recovery
Mode.” Once the Switch enters the “Password Recovery Mode,” all ports on the Switch
will be disabled.
Boot Procedure V1.10.002
-------------------------------------------------------------------------------
Power On Self Test ........................................ 100 %
MAC Address : B0-C5-54-30-00-A0
H/W Version : A1
Please Wait, Loading V1.10.013 Runtime Image .............. 100 %
UART init ................................................. 100 %
Starting runtime image
3. In the “Password Recovery Mode” only the following commands can be used.
Command Parameters
reset config {force_agree} The reset config command resets the whole configuration back
to the default values. The option force_agree means to reset the
whole configuration without the user’s agreement.
reboot The reboot command exits the Reset Password Recovery
Mode and restarts the switch. A confirmation message will be
displayed to allow the user to save the current settings.
To Next Page
Loading...
