D-Link DGS-3000 - Chapter 40 Ipv6 Neighbor Discover Command List

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
439
Chapter 40 IPv6 Neighbor Discover
Command List
create ipv6 neighbor_cache ipif <ipif_name 12> <ipv6addr> <macaddr>
delete ipv6 neighbor_cache ipif [<ipif_name 12> | all] [<ipv6addr> | static | dynamic | all]
show ipv6 neighbor_cache ipif [<ipif_name 12> | all] [ipv6address <ipv6addr> | static | dynamic |
all]
config ipv6 nd ns ipif <ipif_name 12> retrans_time <millisecond 0-4294967295>
show ipv6 nd {ipif <ipif_name 12>}
create ipv6 neighbor_cache 40-1
Description
This command is used to add a static neighbor on an IPv6 interface.
Format
create ipv6 neighbor_cache ipif <ipif_name 12> <ipv6addr> <macaddr>
Parameters
ipif - Specify the interface’s name.
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
<ipv6addr> - Enter the IPv6 address of the neighbor.
<macaddr> - Enter the MAC address of the neighbor.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
Create a static neighbor cache entry:
DGS-3000-26TC:admin#create ipv6 neighbor_cache ipif System 3ffc::1 00-01-02-
03-04-05
Command: create ipv6 neighbor_cache ipif System 3ffc::1 00-01-02-03-04-05
Success.
DGS-3000-26TC:admin#