D-Link DGS-3000 - Chapter 24 Dhcpv6 Server Command List

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
297
Chapter 24 DHCPv6 Server Command
List
create dhcpv6 pool <pool_name 12>
delete dhcpv6 pool [<pool_name 12> | all]
show dhcpv6 pool {<pool_name 12>}
config dhcpv6 pool ipv6network_addr <pool_name 12> begin <ipv6networkaddr> end
<ipv6networkaddr>
config dhcpv6 pool domain_name <pool_name 12> <domain_name 255>
config dhcpv6 pool dns_server <pool_name 12> <ipv6addr> {<ipv6addr>}
config dhcpv6 pool lifetime <pool_name 12> preferred_lifetime <sec 60-4294967295>
valid_lifetime <sec 60-4294967295>
config dhcpv6 pool manual_binding <pool_name 12> [add < ipv6addr> client_duid <string 28> |
delete [<ipv6addr> | all] ]
show dhcpv6 manual_binding {<pool_name 12>}
show dhcpv6 binding {<pool_name 12>}
clear dhcpv6 binding {<pool_name 12>}
enable dhcpv6_server
disable dhcpv6_server
show dhcpv6_server {ipif <ipif_name 12>}
config dhcpv6 pool excluded_address <pool_name 12> [add begin <ipv6addr> end <ipv6addr>
| delete [begin <ipv6addr> end <ipv6addr> | all]]
show dhcpv6 excluded_address {<pool_name 12>}
config dhcpv6_server ipif [<ipif_name 12> | all] state [enable | disable]
create dhcpv6 pool 24-1
Description
This command is used to create a DHCPv6 pool for the DHCPv6 server.
Format
create dhcpv6 pool <pool_name 12>
Parameters
<pool_name 12> - Enter the pool name here. This name can be up to 12 characters long.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create a DHCPv6 pool pool1: