D-Link DGS-3000 - Chapter 61 Password Recovery Command List

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
641
Chapter 61 Password Recovery
Command List
enable password_recovery
disable password_recovery
show password_recovery
enable password_recovery 61-1
Description
This command is used to enable the password recovery mode.
Format
enable password_recovery
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To enable the password recovery mode:
DGS-3000-26TC:admin#enable password_recovery
Command: enable password_recovery
Success.
DGS-3000-26TC:admin#
disable password_recovery 61-2
Description
This command is used to disable the password recovery mode.
Format
disable password_recovery