D-Link DGS-3000 - Config Authentication Ports

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
147
config authentication mac_format 14-6
Description
This command is used to set the MAC address format that will be used for authentication
username via the RADIUS server.
Format
config authentication mac_format {case [lowercase | uppercase] | delimiter {[hyphen | colon
| dot | none] | number [1 | 2 | 5]}(1)}(1)
Parameters
case - Specify the case format used.
lowercase - Specify using the lowercase format, the RADIUS authentication username will be
formatted as: aa-bb-cc-dd-ee-ff.
uppercase - Specify using the uppercase format, the RADIUS authentication username will
be formatted as: AA-BB-CC-DD-EE-FF.
delimiter - Specify the delimiter format used.
hyphen - Specify using the “-“ as delimiter, the format is: AA-BB-CC-DD-EE-FF
colon - Specify using the “:“ as delimiter, the format is: AA:BB:CC:DD:EE:FF
dot - Specify using the “.“ as delimiter, the format is: AA.BB.CC.DD.EE.FF
none - Specify not using any delimiter, the format is: AABBCCDDEEFF
number - Specify the delimiter number used.
1 - Single delimiter, the format is: AABBCC.DDEEFF
2 - Double delimiter, the format is: AABB.CCDD.EEFF
5 - Multiple delimiter, the format is: AA.BB.CC.DD.EE.FF
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the MAC address format to IETF style:
DGS-3000-26TC:admin#config authentication mac_format case uppercase delimiter
hyphen number 5
Command: config authentication mac_format case uppercase delimiter hyphen
number 5
Success.
DGS-3000-26TC:admin#
config authentication ports 14-7
Description
This command is used to configure authorization mode and authentication method on ports.