D-Link DGS-3000 - Create Cfm Mep <String 32> Mepid <Int 1-8191> MD; Port <Port

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
164
DGS-3000-26TC:admin#config cfm ma op1 md op_domain vlanid 1 ccm_interval 1sec
Command: config cfm ma op1 md op_domain vlanid 1 ccm_interval 1sec
Success.
DGS-3000-26TC:admin#
create cfm mep 16-5
Description
This command is used to create an MEP. Different MEPs in the same MA must have a different
MEPID. MD name, MA name, and MEPID that together identify a MEP.
Different MEPs on the same device must have a different MEP name. Before creating an MEP, its
MEPID should be configured in the MA’s MEPID list.
Format
create cfm mep <string 32> mepid <int 1-8191> md [<string 22> | md_index <uint 1-
4294967295>] ma [<string 22> | ma_index <uint 1-4294967295>] direction [inward | outward]
port <port>
Parameters
<string 32> - Enter the MEP name used. It is unique among all MEPs configured on the
device.This name can be up to 32 characters long.
mepid - Specify the MEP ID. It should be configured in the MA’s MEPID list.
<int 1-8191> - Enter the MEP ID used here. This value must be between 1 and 8191.
md - Specify the maintenance domain name.
<string 22> - Enter the maintenance domain name used here. This name can be up to 22
characters long.
md_index - Specify the maintenance domain index.
<uint 1-4294967295> - Enter the maintenance domain index value here. This value must
be between 1 and 4294967295.
ma - Specify the maintenance association name.
<string 22> - Enter the maintenance association name used here. This name can be up to 22
characters long.
ma_index - Specify the maintenance association index.
<uint 1-4294967295> - Enter the maintenance association index value here. This value
must be between 1 and 4294967295.
direction - Specify the MEP direction.
inward - Specify the inward facing (up) MEP.
outward - Specify the outward facing (down) MEP.
port - Specify the port number. This port should be a member of the MA’s associated VLAN.
<port> - Enter the port number used here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create a CFM MEP: