DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
79
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To display the parameters of authentication:
DGS-3000-26TC:admin#show authen parameter
Command: show authen parameter
Response Timeout : 60 seconds
User Attempts : 9
enable admin 5-29
Description
This command is used to enter the administrator level privilege. Promote the "user" privilege level
to "admin" level. When the user enters this command, the authentication method TACACS,
XTACACS, TACACS+, user-defined server groups, local_enable or none will be used to
authenticate the user. Because TACACS, XTACACS and RADIUS don't support "enable" function
in itself, if user wants to use either one of these 3 protocols to do enable authentication, user must
create a special account on the server host first, which has a username "enable" and then
configure its password as the enable password to support "enable" function.
This command can not be used when authentication policy is disabled.
Format
enable admin
Parameters
None.
Restrictions
None.
Example
To enable administrator lever privilege:
To Next Page
Loading...
Need help?
General