D-Link DGS-3000 - Disable Stp; Config Stp

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
609
DGS-3000-26TC:admin#enable stp
Command: enable stp
Success.
DGS-3000-26TC:admin#
disable stp 56-2
Description
This command is used to disable STP globally.
Format
disable stp
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable STP:
DGS-3000-26TC:admin#disable stp
Command: disable stp
Success.
DGS-3000-26TC:admin#
config stp 56-3
Description
This command is used to configure the bridge parameters global settings.
Format
config stp {maxage <value 6-40> | maxhops <value 6-40> | hellotime <value 1-2> |
forwarddelay <value 4-30> | txholdcount <value 1-10> | fbpdu [enable | disable] |
nni_bpdu_addr [dot1d | dot1ad]}
Parameters
maxage - (Optional) Specify to determine if a BPDU is valid. The default value is 20.