D-Link DGS-3000 - Show Snmp Traps; Config Rmon Trap

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
774
show snmp traps 78-37
Description
This command is used to display the SNMP trap sending status.
Format
show snmp traps {linkchange_traps {ports <portlist>}}
Parameters
linkchange_traps - (Optional) Specify that the SNMP trap sending status will be displayed.
ports - (Optional) Specify the ports for the display.
<portlist> - Enter the list of ports used for the display here.
Restrictions
None.
Example
DGS-3000-26TC:admin#show snmp traps
Command: show snmp traps
SNMP Traps : Enabled
Authenticate Trap : Enabled
Linkchange Traps : Enabled
Coldstart Traps : Enabled
Warmstart Traps : Enabled
DGS-3000-26TC:admin#
config rmon trap 78-38
Description
This command is used to configure the trap state for RMON events.
Format
config rmon trap {rising_alarm [enable | disable] | falling_alarm [enable | disable]} (1)
Parameters
rising_alarm - Specify the trap state for rising alarm. The default state is enabled.
enable - Specify that the rising alarm function will be enabled.
disable - Specify that the rising alarm function will be disabled.
falling_alarm - Specify the trap state for falling alarm. The default state is enabled.
enable - Specify that the falling alarm function will be enabled.
disable - Specify that the falling alarm function will be disabled.