D-Link DGS-3000 - Chapter 22 DHCP Server Screening Command List

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
273
Chapter 22 DHCP Server Screening
Command List
create filter dhcpv6_server permit sip <ipv6addr> ports [<portlist> | all]
create filter icmpv6_ra_all_node permit sip <ipv6addr> ports [<portlist> | all]
config filter dhcp_server [add permit server_ip <ipaddr> {client_mac <macaddr>} ports
[<portlist> | all] | delete permit server_ip <ipaddr> {client_mac <macaddr>} ports [<portlist> | all]
| ports [<portlist> | all] state [enable | disable] | illegal_server_log_suppress_duration [1min |
5min | 30min] | trap_log [enable | disable]]
config filter dhcpv6_server log [enable | disable]
config filter dhcpv6_server ports [<portlist> | all] state [enable | disable]
config filter dhcpv6_server trap [enable | disable]
config filter icmpv6_ra_all_node log [enable | disable]
config filter icmpv6_ra_all_node ports [<portlist> | all] state [enable | disable]
config filter icmpv6_ra_all_node trap [enable | disable]
delete filter dhcpv6_server permit sip <ipv6addr>
delete filter icmpv6_ra_all_node permit sip <ipv6addr>
show filter dhcp_server
show filter dhcpv6_server
show filter icmpv6_ra_all_node
create filter dhcpv6_server permit sip 22-1
Description
This command is used to create a permit entry for DHCPv6 server filtering. The specific DHCPv6
server packets, with the source IPv6 address, will be forwarded on the specified port(s).
Format
create filter dhcpv6_server permit sip <ipv6addr> ports [<portlist> | all]
Parameters
<ipv6addr> - Enter the source address of the entry which will be created into the Filter DHCPv6
server forward list.
ports - Specify the list of ports used for this configuration.
<portlist> - Enter the list of ports, used for this configuration, here.
all - Specify that all ports will be used for this configuration.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create a Filter DHCPv6 server permit entry on port 5: