D-Link DGS-3000 - Show Snmp V6 Host

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
763
Format
show snmp host {<ipaddr>}
Parameters
<ipaddr> - (Optional) Enter the IP address of the recipient for which the traps are targeted.
If no parameter specified, all SNMP hosts will be displayed.
Restrictions
None.
Example
To show SNMP host:
DGS-3000-26TC:admin#show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name / SNMPv3 User Name
--------------- --------------- ---------------------------------
10.90.90.3 V3 noauthnopriv initial
10.90.90.2 V2c private
10.90.90.1 V1 public
10.90.90.4 V3 authnopriv user123
10.90.90.5 V3 authpriv user234
Total Entries : 5
DGS-3000-26TC:
show snmp v6host 78-20
Description
This command is used to display the SNMP version 6 hosts.
Format
show snmp v6host {<ipv6addr>}
Parameters
<ipv6addr> - (Optional) Enter the IPv6 host address used for the configuration here.
If no parameter specified, SNMP version 6 hosts will be displayed.
Restrictions
None.