D-Link DGS-3000 - Show Gvrp; Enable Gvrp

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
35
Example
To set the Join time to 200 milliseconds:
DGS-3000-26TC:admin#config gvrp timer join 200
Command: config gvrp timer join 200
Success.
DGS-3000-26TC:admin#
show gvrp 3-16
Description
This command is used to display the GVRP global setting.
Format
show gvrp
Parameters
None.
Restrictions
None.
Example
To display the global setting of GVRP:
DGS-3000-26TC:admin#show gvrp
Command: show gvrp
Global GVRP : Disabled
Join Time : 200 Milliseconds
Leave Time : 600 Milliseconds
LeaveAll Time : 10000 Milliseconds
NNI BPDU Address: dot1d
DGS-3000-26TC:admin#
enable gvrp 3-17
Description
This commands is used to enable the Generic VLAN Registration Protocol (GVRP).