D-Link DGS-3000 - Config Ssh Authmode

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
726
DGS-3000-26TC:admin#show ssh algorithm
Command: show ssh algorithm
Encryption Algorithm
--------------------------
3DES : Enabled
AES128 : Enabled
AES192 : Enabled
AES256 : Enabled
Arcfour : Enabled
Blowfish : Enabled
Cast128 : Enabled
Twofish128 : Enabled
Twofish192 : Enabled
Twofish256 : Enabled
Data Integrity Algorithm
--------------------------
MD5 : Enabled
SHA1 : Enabled
Public Key Algorithm
--------------------------
RSA : Enabled
DSA : Enabled
DGS-3000-26TC:admin#
config ssh authmode 74-3
Description
This command is used to configure user authentication method for SSH.
Format
config ssh authmode [password | publickey | hostbased] [enable | disable]
Parameters
password - Specify the user authentication method using password.
publickey - Specify the user authentication method using public key.
hostbased - Specify the user authentication method using host-based.
enable - Enables the user authentication method.
disable - Disables the user authentication method.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.