DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
768
DGS-3000-26TC:admin#config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
Success.
config snmp system_contact 78-27
Description
This command is used to enter the name of a contact person who is responsible for the Switch.
Format
config snmp system_contact {<sw_contact>}
Parameters
<sw_contact> - (Optional) Enter the SNMP system contact string here. This name can be up to
255 characters long.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the Switch contact to “MIS Department II”:
DGS-3000-26TC:admin#config snmp system_contact "MIS Department II"
Command: config snmp system_contact "MIS Department II"
Success.
enable snmp traps 78-28
Description
This command is used to enable SNMP trap support.
Format
enable snmp traps
Parameters
None.
To Next Page
Loading...
Need help?
General