D-Link DGS-3000 - Delete Ipif; Enable Ipif

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
129
delete ipif 10-15
Description
This command is used to delete an IP interface.
Format
delete ipif [<ipif_name 12> {ipv6address <ipv6networkaddr>} | all]
Parameters
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters
long.
ipv6address - (Optional) Specify the IPv6 network address. The address should specify a host
address and length of network prefix. There can be multiple IPv6 addresses defined on an
interface.
<ipv6networkaddr> - Enter the IPv6 address used here.
all - Specify that all the IP interfaces will be used.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete an IP interface:
DGS-3000-26TC:admin#delete ipif newone
Command: delete ipif newone
Success.
DGS-3000-26TC:admin#
enable ipif 10-16
Description
This command is used to enable the IP interface.
Format
enable ipif [<ipif_name 12> | all]
Parameters
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters
long.
all - Specify that all the IP interfaces will be enabled.