D-Link DGS-3000 - Enable Loopdetect; Disable Loopdetect

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
513
enable loopdetect 47-3
Description
This command is used to enable the LBD function globally on the Switch. The default state is
disabled.
Format
enable loopdetect
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the LBD function globally:
DGS-3000-26TC:admin#enable loopdetect
Command: enable loopdetect
Success.
DGS-3000-26TC:admin#
disable loopdetect 47-4
Description
This command is used to disable the LBD function globally on the Switch.
Format
disable loopdetect
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable the LBD function globally: