D-Link DGS-3000 - Config Authen Parameter Attempt; Show Authen Parameter

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
78
Example
To configure the amount of time waiting or user input to be 60 seconds:
DGS-3000-26TC:admin#config authen parameter response_timeout 60
Command: config authen parameter response_timeout 60
Success.
DGS-3000-26TC:admin#
config authen parameter attempt 5-27
Description
This command is used to configure the maximum attempts for user's trying to login or promote the
privilege on console, Telnet, or SSH application.
Format
config authen parameter attempt <int 1-255>
Parameters
<int 1-255> - Enter the amount of attempts for user's trying to login or promote the privilege on
console, Telnet or SSH. This value must be between 1 and 255. Default value is 3.
Restrictions
Only Administrators can issue this command.
Example
To configure the maximum attempts for user's trying to login or promote the privilege to be 9:
DGS-3000-26TC:admin#config authen parameter attempt 9
Command: config authen parameter attempt 9
Success.
DGS-3000-26TC:admin#
show authen parameter 5-28
Description
This command is used to display the parameters of authentication.
Format
show authen parameter