DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
262
Restrictions
Administrators, Operators and Power-Users can issue this command.
Example
To add an address range for DHCP class1 in pool1, and display DHCP pool information:
DGS-3000-26TC:admin#config dhcp pool class pool1 add class1 begin_address
20.0.0.20 end_address 20.0.0.50
Command: config dhcp pool class pool1 add class1 begin_address 20.0.0.20
end_address 20.0.0.50
Success.
clear dhcp binding 21-26
Description
This command is used to clear a binding entry or all binding entries in a pool or clears all binding
entries in all pools. Note that this command will not clear the dynamic binding entry which matches
a manual binding entry.
Format
clear dhcp binding [<pool_name 12> [<ipaddr> | all] | all]
Parameters
<pool_name 12> - Enter the DHCP pool name to clear.
<ipaddr> - Enter the IP address to clear.
all - Specify to clear all IP addresses for the specified pool.
all - Specify to clear all binding entries in all pools
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To clear dynamic binding entries in the pool named “engineering”:
DGS-3000-26TC:admin#clear dhcp binding engineering 10.48.74.121
Command: clear dhcp binding engineering 10.48.74.121
Success.
To Next Page
Loading...
