D-Link DGS-3000 - Show Time

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
830
must be in the hh:mm format.
e_date - (Optional) Specify the end date of Daylight Saving Time.
<end_date 1-31> - Enter the ending date of Daylight Saving Time here. This range must
be between 1 an 31.
e_mth - (Optional) Specify the end month number of Daylight Saving Time.
<end_mth 1-12> - Enter the ending month number of Daylight Saving Time here. This
value must be between 1 and 12.
e_time - (Optional) Specify the end time of Daylight Saving Time.
<end_time hh:mm> - Enter the starting time of Daylight Saving Time here. This value
must be in the hh:mm format.
offset - (Optional) Indicates number of minutes to add or to subtract during summertime. The
ranges of offset are 30, 60, 90,120; default value is 60.
30 - Specify that the offset range will 30 minutes.
60 - Specify that the offset range will 60 minutes.
90 - Specify that the offset range will 90 minutes.
120 - Specify that the offset range will 120 minutes.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure time:
DGS-3000-26TC:admin#config dst repeating s_week 2 s_day tue s_mth 4 s_time
15:00 e_week2 e_day wed e_mth 10 e_time 15:30 offset 30
Command: config dst repeating s_week 2 s_day tue s_mth 4 s_time 15:00 e_week 2
e_day wed e_mth 10 e_time 15:30 offset 30
Success.
DGS-3000-26TC:admin#
show time 87-9
Description
This command is used to display time states.
Format
show time
Parameters
None.
Restrictions
None.