D-Link DGS-3000 - Config Authentication Server Failover

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
149
DGS-3000-26TC:admin#config authentication ports all auth_mode host_based
Command: config authentication ports all auth_mode host_based
Success.
DGS-3000-26TC:admin#
The following example sets the compound authentication method of all ports to “any”:
DGS-3000-26TC:admin#config authentication ports all multi_authen_methods any
Command: config authentication ports all multi_authen_methods any
Success.
DGS-3000-26TC:admin#
config authentication server failover 14-8
Description
This command is used to configure authentication server failover function.
Format
config authentication server failover [local | permit | block]
Parameters
local - Uses local DB to authenticate the client.
permit - The client is always regarded as authenticated.
block - Blocks the client. This is the default.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
Set authentication server auth fail over state:
DGS-3000-26TC:admin#config authentication server failover local
Command: config authentication server failover local
Success.
DGS-3000-26TC:admin#