D-Link DGS-3000 User Manual

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
114
Chapter 9 Auto-Configuration
Command List
enable autoconfig
disable autoconfig
show autoconfig
config autoconfig timeout <value 1-65535>
enable autoconfig 9-1
Description
This command is used to enable auto configuration. When enabled, during power on initialization,
the Switch will get configure file path name and TFTP server IP address from the DHCP server.
Then, the Switch will download the configuration file from the TFTP server for configuration of the
system.
Format
enable autoconfig
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable autoconfig:
DGS-3000-26TC:admin#enable autoconfig
Command: enable autoconfig
Success.
DGS-3000-26TC:admin#
disable autoconfig 9-2
Description
This command is used to disable auto configuration. When disabled, the Switch will configure itself
using the local configuration file

D-Link DGS-3000 Specifications

General

Brand	D-Link
Model	DGS-3000
Category	Switch
Language	English