DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
516
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To specify that traps will be sent when the loop condition is detected or cleared:
DGS-3000-26TC:admin#config loopdetect trap both
Command: config loopdetect trap both
Success.
config loopdetect log 47-8
Description
This command is used to configure the log state for LBD. The default value is enabled.
Format
config loopdetect log state [enable | disable]
Parameters
state - Specify the state of the LBD log feature.
enable - Enables the LBD log feature.
disable - Disables the LBD log feature. All LBD-related logs will not be recorded.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the log state for LBD:
DGS-3000-26TC:admin#config loopdetect log state enable
Command: config loopdetect log state enable
Success.
To Next Page
Loading...
