D-Link DGS-3000 - Config Lldp Ports

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
488
config lldp notification_interval 46-4
Description
This command is used to configure the timer of notification interval for sending notification to
configured SNMP trap receiver(s).
Format
config lldp notification_interval <sec 5-3600>
Parameters
notification_interval - Specify the timer of notification interval for sending notification to
configured SNMP trap receiver(s). The default setting is 5 seconds.
<sec 5-3600> - Enter the notification interval value here. This value must be between 5 and
3600 seconds.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To changes the notification interval to 10 second:
DGS-3000-26TC:admin#config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
DGS-3000-26TC:admin#
config lldp ports 46-5
Description
This command is used to configure each port for sending a notification to configure the SNMP trap
receiver(s).
Format
config lldp ports [<portlist> | all] [notification [enable | disable] | admin_status [tx_only |
rx_only | tx_and_rx | disable] | mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] [enable | disable]
| basic_tlvs [{all} | {port_description | system_name | system_description |
system_capabilities}] [enable | disable] | dot1_tlv_pvid [enable| disable] |
dot1_tlv_protocol_vid [vlan [all | <vlan_name 32> ] | vlanid <vidlist>] [enable | disable] |
dot1_tlv_vlan_name [vlan [all | <vlan_name 32>] | vlanid <vidlist>] [enable | disable] |
dot1_tlv_protocol_identity [all | {eapol | lacp | gvrp | stp }] [enable | disable] | dot3_tlvs [{all}
| {mac_phy_configuration_status | link_aggregation | power_via_mdi |
maximum_frame_size}] [enable | disable]]