D-Link DGS-3000 - Chapter 80 Single IP Management Command List

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
781
Chapter 80 Single IP Management
Command List
enable sim
disable sim
show sim {[candidates {<candidate_id 1-100>} | members{<member_id 1-32>} | group
{commander_mac <macaddr>} | neighbor]}
reconfig {member_id <value 1-32> | exit}
config sim_group [add <candidate_id 1-100> {<password>} | delete <member_id 1-32>]
config sim [[commander {group_name <groupname 64>} | candidate] | dp_interval <sec 30-90> |
hold_time <sec 100-255>]
download sim_ms [firmware_from_tftp | configuration_from_tftp] {[<ipaddr> | <ipv6addr>]
<path_filename> {[members <mslist 1-32> | all]}}
upload sim_ms [configuration_to_tftp | log_to_tftp] {[<ipaddr> | <ipv6addr>] <path_filename>
{[members <mslist> | all]}}
config sim trap [enable | disable]
enable sim 80-1
Description
This command is used to configure the single IP management on the Switch as enabled.
Format
enable sim
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable SIM:
DGS-3000-26TC:admin#enable sim
Command: enable sim
Success.
DGS-3000-26TC:admin#