D-Link DGS-3000 - Chapter 23 Dhcpv6 Relay Command List

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
285
Chapter 23 DHCPv6 Relay Command
List
enable dhcpv6_relay
enable dhcpv6_local_relay
disable dhcpv6_relay
disable dhcpv6_local_relay
config dhcpv6_relay [add | delete] ipif <ipif_name 12> <ipv6addr>
config dhcpv6_relay hop_count <value 1-32>
config dhcpv6_relay ipif [<ipif_name 12> | all] state [enable | disable]
config dhcpv6_local_relay vlan [<vlan_name 32> |vlanid <vlan_id>] state [enable | disable]
config dhcpv6_relay option_18 {state [enable | disable] | check [enable | disable] | interface_id
[default | cid | vendor1]}(1)
config dhcpv6_relay option_37 {state [enable | disable] | check [enable | disable] | remote_id
[default | cid_with_user_define <desc 128> | user_define <desc 128> | vendor1]}(1)
show dhcpv6_relay {ipif <ipif_name 12>}
show dhcpv6_local_relay
enable dhcpv6_relay 23-1
Description
This command is used to enable the DHCPv6 relay function on the Switch.
Format
enable dhcpv6_relay
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the DHCPv6 relay global state to enable:
DGS-3000-26TC:admin# enable dhcpv6_relay
Command: enable dhcpv6_relay
Success.
DGS-3000-26TC:admin#