D-Link DGS-3000 - Show Sntp

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
825
DGS-3000-26TC:admin#config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-
interval 30
Command: config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Success.
DGS-3000-26TC:admin#
config sntp ipv6server 87-2
Description
This command is used to configure the SNTP IPv6 server information.
Format
config sntp ipv6server {primary <ipv6addr> | secondary <ipv6addr> }(1)
Parameters
primary - SNTP primary IPv6 server address.
<ipv6addr> - Enter the IPv6 address of the Primary SNTP IPv6 server.
secondary - SNTP secondary IPv6 server address.
<ipv6addr> - Enter the IPv6 address of the Secondary SNTP IPv6 server.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure SNTP (primary IPv6 server: 1000::1, secondary IPv6 server: 1000::2):
DGS-3000-26TC:admin#config sntp ipv6server primary 1000::1 secondary 1000::2
Command: config sntp ipv6server primary 1000::1 secondary 1000::2
Success.
DGS-3000-26TC:admin#
show sntp 87-3
Description
This command is used to display SNTP current time source and configuration.
Format
show sntp