D-Link DGS-3000 - Config Ipif

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
127
Format
create ipif <ipif_name 12> <network_address> <vlan_name 32> {state [enable|disable]}
Parameters
ipif - Specify the name of the IP interface.
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
<network_address> - Enter the IPv4 network address (xx.xx.xx.xx/xx). It Specify a host address
and length of network mask.
<vlan_name 32> - Enter the VLAN name used here. This name can be up to 32 characters long.
state - (Optional) Specify the state of the IP interface.
enable - Specify that the IP interface state will be enabled.
disable - Specify that the IP interface state will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create an IP interface:
DGS-3000-26TC:admin#create ipif Inter2 192.168.16.1/24 default state enable
Command: create ipif Inter2 192.168.16.1/24 default state enable
Success.
DGS-3000-26TC:admin#
config ipif 10-14
Description
This command is used to configure the IP interface.
Format
config ipif <ipif_name 12> [{ipaddress <network_address> | vlan <vlan_name 32> | state
[enable | disable]} | bootp | dhcp | ipv6 [ipv6address <ipv6networkaddr> | state [enable |
disable]] | ipv4 state [enable | disable] | dhcpv6_client [enable | disable] | dhcp_option12
[hostname <hostname 63> | clear_hostname | state [enable | disable]]
Parameters
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters
long.
ipaddress - (Optional) Configures a network on an ipif. The address should specify a host
address and length of network mask. Since an ipif can have only one IPv4 address, the new
configured address will overwrite the original one.
<network_address> - Enter the network address used here.
vlan - (Optional) Specify the name of the VLAN here.