DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
122
DGS-3000-26TC:admin#show switch
Command: show switch
Device Type : DGS-3000-26TC Gigabit Ethernet Switch
MAC Address : 00-01-02-03-04-00
IP Address : 10.90.90.90 (Manual)
VLAN Name : default
Subnet Mask : 255.0.0.0
Default Gateway : 0.0.0.0
Boot PROM Version : Build 1.00.002
Firmware Version : Build 1.10.013
Hardware Version : A1
System Name :
System Location :
System Uptime : 0 days, 2 hours, 2 minutes, 52 seconds
System Contact :
Spanning Tree : Disabled
GVRP : Disabled
IGMP Snooping : Disabled
MLD Snooping : Disabled
VLAN Trunk : Disabled
Telnet : Enabled (TCP 23)
Web : Enabled (TCP 80)
SNMP : Disabled
SSL Status : Disabled
enable telnet 10-6
Description
This command is used to enable Telnet and configure port number.
Format
enable telnet {<tcp_port_number 1-65535>}
Parameters
<tcp_port_number 1-65535> - (Optional) The TCP port number. TCP ports are numbered
between 1 and 65535. The “well-known” TCP port for the Telnet protocol is 23.
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable Telnet and configure port number:
To Next Page
Loading...
