D-Link DGS-3000 - Show Syslog; Create Syslog Host

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
806
show syslog 83-6
Description
This command is used to display the syslog protocol global state.
Format
show syslog
Parameters
None.
Restrictions
None.
Example
To display the syslog protocol global state:
DGS-3000-26TC:admin#show syslog
Command: show syslog
Syslog Global State: Enabled
DGS-3000-26TC:admin#
create syslog host 83-7
Description
This command is used to create a new syslog host. The user can choose and report specific levels
of messages to a specific host. When the user chooses a specific level for a specific host,
messages which are at that severity level or higher will be reported to that host.
Format
create syslog host <index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity [emergency |
alert | critical | error | warning | notice | informational | debug | <level 0-7>] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> | state
[enable | disable]}
Parameters
<index 1-4> - Enter the host index value here.
ipaddress - Specify the IP address for the host.
<ipaddr> - Enter the IP address for the host.
<ipv6addr> - Enter the IPv6 address for the host.
severity - (Optional) Specify the severity level.
emergency - Severity level 0.
alert - Severity level 1.