DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
619
DGS-3000-26TC:admin#config stp version mstp
Command: config stp version mstp
Success.
To config STP version with the same value of old configuration:
DGS-3000-26TC:admin#config stp version mstp
Command: config stp version mstp
Configure value is the same with current value.
Success.
show stp instance 56-15
Description
This command is used to display each instance parameters settings. Value means the instance ID,
if there is no input of this value, all instance will be shown.
Format
show stp instance {<value 0-7>}
Parameters
instance - Specify the MSTP instance ID.
<value 0-7> - (Optional) Enter the MSTP instance ID value here. This value must be between
Restrictions
None.
Example
To show STP instance:
To Next Page
Loading...
Need help?
General