DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
769
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable SNMP trap support:
DGS-3000-26TC:admin#enable snmp traps
Command: enable snmp traps
Success.
disable snmp traps 78-29
Description
This command is used to disable SNMP trap support on the Switch.
Format
disable snmp traps
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To prevent SNMP traps from being sent from the Switch:
DGS-3000-26TC:admin#disable snmp traps
Command: disable snmp traps
Success.
enable snmp authenticate_traps 78-30
Description
This command is used to enable SNMP authentication failure trap support.
To Next Page
Loading...
