D-Link DGS-3000

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
802
Chapter 83 System Log Command List
clear log
show log {[index <value_list> | severity {module <module_list>} {emergency | alert | critical | error |
warning | notice | informational | debug | <level_list 0-7>} | module<module_list>]}
show log_software_module
enable syslog
disable syslog
show syslog
create syslog host <index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity [emergency | alert |
critical | error | warning | notice | informational | debug | <level 0-7>] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> | state [enable |
disable]}
config syslog host [<index> | all] {severity [emergency | alert | critical | error | warning | notice |
informational | debug| <level 0-7>] | facility [local0 | local1 | local2 | local3 | local4 | local5 |
local6 | local7] | udp_port <udp_port_number> | ipaddress [<ipaddr> | <ipv6addr>] | state
[enable | disable]}(1)
delete syslog host [<index 1-4> | all]
show syslog host {<index 1-4>}
config log_save_timing [time_interval <min 1-65535> | on_demand | log_trigger]
show log_save_timing
show attack_log {index <value_list>}
clear attack_log
clear log 83-1
Description
This command is used to clear the Switch’s history log.
Format
clear log
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To clear the Switch’s history log: