D-Link DGS-3000 - Show Lldp

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
493
disable - Disable the forwarding of LLDP-PDU events. By default it is disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure LLDP to forward LLDP PDUs:
DGS-3000-26TC:admin#config lldp forward_message enable
Command: config lldp forward_message enable
Success.
DGS-3000-26TC:admin#
show lldp 46-7
Description
This command is used to display the Switch’s general LLDP configuration status.
Format
show lldp
Parameters
None.
Restrictions
None.
Example
To display the LLDP system level configuration status: