DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
492
DGS-3000-26TC:admin#config lldp ports all dot1_tlv_protocol_vid vlanid 1-3
enable
Command: config lldp ports all dot1_tlv_protocol_vid vlanid 1-3 enable
Success.
To configure exclude the VLAN name TLV from the outbound LLDP advertisements for all ports:
DGS-3000-26TC:admin#config lldp ports all dot1_tlv_vlan_name vlanid 1-3 enable
Command: config lldp ports all dot1_tlv_vlan_name vlanid 1-3 enable
Success.
To configure exclude the protocol identity TLV from the outbound LLDP advertisements for all
ports:
DGS-3000-26TC:admin#config lldp ports all dot1_tlv_protocol_identity all enable
Command: config lldp ports all dot1_tlv_protocol_identity all enable
Success.
To configure exclude the MAC/PHY configuration/status TLV from the outbound LLDP
advertisements for all ports:
DGS-3000-26TC:admin#config lldp ports all dot3_tlvs
mac_phy_configuration_status enable
Command: config lldp ports all dot3_tlvs mac_phy_configuration_status enable
Success.
config lldp forward_ message 46-6
Description
This command is used to configure forwarding of LLDP PDU packet when LLDP is disabled.
Format
config lldp forward_message [enable | disable]
Parameters
enable - Enable the forwarding of LLDP PDU configuration events.
To Next Page
Loading...
