D-Link DGS-3000 - Config Firmware Image; Create Ipif

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
126
Example
To reset the Switch:
DGS-3000-26TC:admin#reset system
Command: reset system
Are you sure you want to proceed with system reset?(y/n)
y-(reset all include configuration, save, reboot )
n-(cancel command) y
Reboot & Load Factory Default Configuration...
Saving configurations and logs to NV-RAM...... Done.
Please wait, the switch is rebooting...
config firmware image 10-12
Description
This command is used to select a firmware file as a boot-up file. This command is required to be
supported when multiple firmware images are supported.
Format
config firmware image <path_filename64>boot_up
Parameters
<path_filename64> - Enter a firmware file on the device file system.
boot_up - Specify the firmware as the boot-up firmware.
Restrictions
Only Administrators can issue this command.
Example
To configure c:/ firmware.had as the boot-up image:
DGS-3000-26TC:admin#config firmware image c:/firmware.had boot_up
Command: config firmware image c:/firmware.had boot_up
Success.
DGS-3000-26TC:admin#
create ipif 10-13
Description
This command is used to create an IP interface.