D-Link DGS-3000

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
125
Format
reboot {force_agree}
Parameters
force_agree - (Optional) The reboot command will be executed immediatedly without further
confirmation.
Restrictions
Only Administrators can issue this command.
Example
To reboot the Switch:
DGS-3000-26TC:admin#reboot
Command: reboot
Are you sure to proceed with the system reboot?(y/n)
Please wait, the switch is rebooting…
reset 10-11
Description
This command is used to provide reset functions. The configuration setting will be reset to the
default setting by the “reset config” command. For the “reset system” command, the device will
store the reset setting in the NVRAM and then reboot the system. The “reset” command will not
reset IP address, log, user accounts and banner configured on the system.
Format
reset {[config | system]} {force_agree}
Parameters
config - (Optional) All parameters are reset to default settings. However, the device will neither
save or reboot.
system - (Optional) All parameters are reset to default settings, and the Switch will reset to
factory default settings, save and reboot.
force_agree - (Optional) The reset command will be executed immediatedly without further
confirmation.
Restrictions
Only Administrators can issue this command.