DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
315
To configure the port 25’s receive power threshold:
DGS-3000-26TC:admin#config ddm ports 25 rx_power_threshold high_alarm 4.55
low_alarm 0.01 high_warning 3.5 low_warning 0.03
Command: config ddm ports 25 rx_power_threshold high_alarm 4.55 low_alarm 0.01
high_warning 3.5 low_warning 0.03
Success.
To configure the port 25’s actions associate with the alarm:
DGS-3000-26TC:admin#config ddm ports 25 state enable shutdown alarm
Command: config ddm ports 25 state enable shutdown alarm
Success.
show ddm 25-3
Description
This command is used to display the DDM global settings.
Format
show ddm
Parameters
None.
Restrictions
None.
Example
To display the DDM global settings:
DGS-3000-26TC:admin#show ddm
Command: show ddm
DDM Log :Enabled
DDM Trap :Disabled
DDM Tx/Rx Power Unit : mw
To Next Page
Loading...
