D-Link DGS-3000 - Chapter 79 Simple RED Command List

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
776
Chapter 79 Simple RED Command List
enable sred
disable sred
config sred [<portlist> | all] [<class_id 0-7> | all] {threshold {low <value 0-100> | high <value 0-
100>} | drop_rate {low <value 1-8> | high <value 1-8>} | drop_green [enable | disable]}
show sred {<portlist> {<class_id 0-7>}}
show sred drop_counter {<portlist>}
enable sred 79-1
Description
This command is used to enable the sRED function. By default, sRED is disabled.
Format
enable sred
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable sRED:
DGS-3000-26TC:admin#enable sred
Command: enable sred
Success.
DGS-3000-26TC:admin#
disable sred 79-2
Description
This command is used to disable the sRED function.
Format
disable sred