D-Link DGS-3000 User Manual

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
141
Chapter 13 Command Logging
Command List
enable command logging
disable command logging
show command logging
enable command logging 13-1
Description
This command is used to enable the command logging function. This is disabled by default.
NOTE: When the Switch is under booting procedure, all configuration command should not be
logged. When the user under AAA authentication, the user name should not changed if
user uses “enable admin” command to replace its privilege.
Format
enable command logging
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To enable the command logging function:
DGS-3000-26TC:admin#enable command logging
Command: enable command logging
Success.
DGS-3000-26TC:admin#
disable command logging 13-2
Description
This command is used to disable the command logging function.

D-Link DGS-3000 Specifications

General

Brand	D-Link
Model	DGS-3000
Category	Switch
Language	English