D-Link DGS-3000

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
572
If no parameter is specified, display the global counters.
Restrictions
Only Administrators can issue this command.
Example
To show the STP counters for port 9:
DGS-3000-26TC:admin#debug stp show counter ports 9
Command: debug stp show counter ports 9
STP Counters
--------------------------------------
Port 9 :
Receive: Transmit:
Total STP Packets : 0 Total STP Packets : 0
Configuration BPDU : 0 Configuration BPDU : 0
TCN BPDU : 0 TCN BPDU : 0
RSTP TC-Flag : 0 RSTP TC-Flag : 0
RST BPDU : 0 RST BPDU : 0
Discard:
Total Discarded BPDU : 0
Global STP Disabled : 0
Port STP Disabled : 0
Invalid packet Format : 0
Invalid Protocol : 0
Configuration BPDU Length : 0
TCN BPDU Length : 0
RST BPDU Length : 0
Invalid Type : 0
Invalid Timers : 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
debug stp clear counter 53-5
Description
This command is used to clear the STP counters.
Format
debug stp clear counter {ports[<portlist> | all]}
Parameters
ports – (Optional)Specify the port range.
<portlist> - Enter the list of port used for this configuration here.
all - Clears all port counters.