D-Link DGS-3000 - Config Vlan

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
26
<vidlist> - Enter the VLAN ID list here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To remove VLANs from 10-30:
DGS-3000-26TC:admin#delete vlan vlanid 10-30
Command: delete vlan vlanid 10-30
Success.
DGS-3000-26TC:admin#
config vlan 3-5
Description
This command is used to configure a VLAN based on the name.
Format
config vlan <vlan_name 32> {[add [tagged | untagged | forbidden] | delete] <portlist> |
advertisement [enable | disable]}(1)
Parameters
<vlan_name 32> - Enter the VLAN name you want to add ports to. This name can be up to 32
characters long.
add - (Optional) Specify to add tagged, untagged or forbidden ports to the VLAN.
tagged - Specify the additional ports as tagged.
untagged - Specify the additional ports as untagged.
forbidden - Specify the additional ports as forbidden.
delete - (Optional) Specify to delete ports from the VLAN.
<portlist> - (Optional) Enter the list of ports used for the configuration here.
advertisement - (Optional) Specify the GVRP state of this VLAN.
enable - Specify to enable advertisement for this VLAN.
disable - Specify to disable advertisement for this VLAN.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To add 4 through 8 as tagged ports to the VLAN v2: