D-Link DGS-3000 - Debug Show Status

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
203
Format
debug show error_reboot state
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To show the debug error reboot state:
DGS-3000-26TC:admin#debug show error_reboot state
Command: debug show error_reboot state
Error Reboot: Enabled
DGS-3000-26TC:admin#
debug show status 18-7
Description
This command is used to display the specified module’s debug status.
Format
debug show status {module <module_list>}
Parameters
module - (Optional) Specify the module to be displayed.
<module_list> - Enter the module to be displayed.
Restrictions
Only Administrators can issue this command.
Example
To show the specified module’s debug state: